ngHobbies
400MW 1.3GHZ 2 CHANNEL TRANSMITTER
Features:, Frequency Band:, 1258MHz and 1280MHz, Number of Channels:, 2, Audio Sub-carrier:, 5.5MHz, Transmission Range:, 500 Meter plus, Power Consumption:, 300mA, Output Power:, 400mW, Operation Voltage:, 12, Power Supply:, 12V/500mA, Antenna Connector:, SMA Connector, Weight:, 8 g, Dimensions:, 50 x 25.7 x 8 mm, Documentation:, , Warranty:, 3 months, Note:, ** The power level of this transmitter may be illegal in your country. Please check your local regulations and make sure you order this device only if you have the required licensing to use this product.,
Highly integrated 1.3 GHz transmitter. These transmitters are supplied with ...ngHobbies
800MW 1.3GHZ 2 CHANNEL TRANSMITTER
Features:, Frequency Band:, 1258MHz and 1280MHz, Number of Channels:, 2, Audio Sub-carrier:, 5.5MHz, Transmission Range:, 1000 Meter plus, Power Consumption:, 600mA, Output Power:, 800mW, Operation Voltage:, 12, Power Supply:, 12V/750mA, Antenna Connector:, SMA Connector, Weight:, 9 g, Dimensions:, 50 x 25.7 x 8 mm, Documentation:, , Warranty:, 3 months, Note:, * The use and operation of this product will require a HAM or Amateur radio license.,
Highly integrated 1.3 GHz transmitter. These transmitters are supplied with ...ngHobbies
600MW 5.8GHZ IMMERSIONRC TRANSMITTER
| Operating Frequencies | 5740, 5760, 5780, 5800, 5820, 5840, 5860MHz |
| Weight | 20 grams |
| Size | 57 x 34mm |
| Input voltage range | 6 - 16 v |
Parameters:, 600mW output power, Content of the package:, 1 x 600mW Transmitter module, Note:, The use and operation of this product in Canada and United States will require a HAM or Amateur radio license. Please check with your local authorities before purchasing this product.,
The Immersion RC's 5.8Ghz 600mW transmitter is a state of ...ngHobbies
LM 1.2GHZ STANDARD RECEIVER
Features:, Frequency Band:, 1200MHz, Number of Channels:, 8, Audio Sub-carrier:, 6.5MHz, Video Output:, 75 Ohm, RCA, Power Consumption:, 240mA, Audio Output:, 10k Ohm, RCA, Power Supply:, 12V/500mA, Antenna Connector:, SMA Connector, Weight:, 95 g, Dimensions:, 80 x 53 x 20 mm, Power Cable:, A power cable to supply power to this recevier from a 3Cell LiPo battery can be found here:, 6" LawMate Power Cable, Documentation:, Datasheet, Warranty:, 6 months, Note:, Please note this receiver comes without a power supply.,
Highly integrated mini 1.2 GHz receiver with well known quality ...ngHobbies
1W LM 1.2GHZ TRANSMITTER
Features:, Frequency Band:, 1200MHz, Number of Channels:, 8, Audio Sub-carrier:, 5.5MHz, Transmission Range:, 500 Meter plus, Power Consumption:, 450mA, Output Power:, 1000mW, Operation Voltage:, 12, Power Supply:, 12V/500mA, Antenna Connector:, SMA Connector, Weight:, 30 g, Dimensions:, 26 x 50 x 13 mm, Documentation:, , Warranty:, 6 months, Note:, The use and operation of this product will require a HAM or Amateur radio license., Important note for Canada customers:,
If this transmitter is ordered/shipped to a USA address, it ...ngHobbies
FAT SHARK TELEPORTER V3
| - Image size | 45"@ 7' |
| - Focal distance | 2 meter object focus |
| - User Controls | Mode selection, Channel Selection (Up/Down) |
| - Supply power | 6-12V |
| - Power consumption | 300mA wireless more. |
| - Weight | 200g |
| - Display | Two full color display modules |
| - Color arrangement | vertical stripe |
| - Resolution | QVGA |
| - Interface | A/V port, battery port. |
| - Video signal | NTSC/PAL Autoselecting |
This version has the following benefits:, - QVGA resolution, The Teleporter System Includes:, Teleporter headset, Product Specification:, - FOV 30 degrees diagonal,
The FatShark Teleporter V3 was redesigned with the Nexwave 5.8Ghz ...ngHobbies
250MW 5.8GHZ FATSHARK TRANSMITTER
| Operating Frequencies | 5740, 5760, 5780, 5800, 5820, 5840, 5860MHz |
| Weight | 14 grams |
| Size | 57 x 25mm |
| Input voltage range | 6 - 16 v |
Parameters:, 250mW output power, Content of the package:, 1 x 250mW Transmitter module, Note:, The use and operation of this product in Canada and United States will require a HAM or Amateur radio license. Please check with your local authorities before purchasing this product.,
The Fatshark 5.8Ghz 250mW transmitter is a state of art ...ngHobbies
FAT SHARK QVGA SPYHAWK GOGGLES
| Field of view (FOV) | 20 degrees diagonal |
| Interpupillary distance (IPD) | 63.5mm fixed |
| Power supply | 7-13V(2S/3S battery) |
| Battery | 7.4V, 2 cell Lithium Polymer |
Please note:, Fat Shark is not compatible with other chinese brand transmitters. Fat Shark can only guarantee compatibility with Fat Shark and ImmersionRC transmitters., Fat Shark QVGA Spyhawk package includes:, QVGA headset with integrated 5G8 Nexwave receiver (no head tracking)., Specifications:, , Optics:, Audio:, Stereo, User Controls:, Up/Down Channel selection, Electrical:, Power consumption:, 300mAh in wireless mode, Antenna:, External, circular polarized spironet receiving antenna, Display:, Full color binoculad QVGA LCOS display (230k pixels), Interface:, 3.5mm AV in/out port,
The Fat Shark QVGA Spyhawk goggles with built in high ...ngHobbies
3 METER DOMINATOR AV CABLE
| Yellow | Video |
| White | Audio Left |
| Red | Audio Right |
| Black female | Battery (power up to 12V) in |
| Black male | Battery (cross from the above battery in) out |
Compatible with:, Fatshark Dominator,
This 3m AV cable allows the user to share base ...ngHobbies
3M BASE FUTABA/RCA MULTI HEAD AV
| Yellow | Video |
| White | Audio Left |
| Red | Audio Right |
| Black female | Battery (power up to 12V) in |
| Black male | Battery (cross from the above battery in) out |
Compatible with:, Fatshark RCV922 Base,
This 3m AV cable allows the user to share base ...ngHobbies
HIMAX CR3516-1030 CONTRA ROTATING MOTORS
| Weight | 275g, (9.7oz) with prop adapter |
| Max Power | 400W, (This is dependent on several factors) |
| Max RPM | 12,000 RPM |
| Diameter | 35.3mm, (1.39") |
| Length | 34mm(1.34") |
| Shaft Diameter | 4.73mm (3/16") front shaft, 9.48mm (3/8") rear shaft |
| Motor Mounting Holes | 4 holes, 3.17mm through, on 43mm, (1.7") bolt circle |
| Maximum Case Temperature | 65oC, (149oF) |
| Suggested Props | For 3-cell operation APC 12x6P front prop, APC 11x8E rear prop |
| Battery | 3-cell Lipo that can sustain 70 to 80 amp continuous draw. |
| ESC setting | Cutoff - soft, Brake - disabled, Throttle type - airplane, fixed endpoints. |
Features:, High Efficiency - High Power - High Torque - Lightweight - Equivalent to .30 size glow engine., Specifications:, ESC: Two Phoenix 35 or equivalent. Also needs a MPI 2160 or 2460 Y-harness to join the two ESC to throttle channel., Special note:,
KV= 1030, Rm = .0.035, Io = TBA Efficient Operating ...ngHobbies
QUADRO2 XL COMBI ASSEMBLED DISTRIBUTION BOARD
| • voltage | 10 to 30V -> 3 -7S Lipo |
| • current | up to 60A (per BL-Unit) and 120A (all together) with appropriate cooling |
| • Silent Start | test tone at startup can be disabled |
| • hole | 3mm |
| • weight | ca. 109g |
IMPORTANT:, Use FlightCtrl Firmware V2.02 (or greater), otherwise read the instructions in the wiki !, : The BL-Ctrl 3.0 controller is specifically designed and optimized for our motors. For maximum stability of the MikroKopter set-points are set almost instantaneously on the motor. If other motors (especially larger power classes) are used with this controller, this fast change of set-points can easily lead to very high peak currents, which bring the BL-Ctrl control to the limit or an overload. This is no fault of BL-Ctrl3.0 controller, but a systemic property., Power:, Mechanical data:, , • Dimensions (W x H ):, In the package:, • 2 SMD preassembled, programmed and tested boards already mounted and soldered, Links:,
4 ESCs on two boards! Extremely fast brushless controllers version ...ngHobbies
OKTO XL COMBI ASSEMBLED DISTRIBUTION BOARD
| • voltage | 10 to 30V -> 3 -7S Lipo |
| • current | up to 60A (per BL-Unit) and 120A (all together) with appropriate cooling |
| • Silent Start | test tone at startup can be disabled |
| • hole | 3mm |
| • weight | ca. 109g |
IMPORTANT:, Use FlightCtrl Firmware V2.02 (or greater), otherwise read the instructions in the wiki !, : The BL-Ctrl 3.0 controller is specifically designed and optimized for our motors. For maximum stability of the MikroKopter set-points are set almost instantaneously on the motor. If other motors (especially larger power classes) are used with this controller, this fast change of set-points can easily lead to very high peak currents, which bring the BL-Ctrl control to the limit or an overload. This is no fault of BL-Ctrl3.0 controller, but a systemic property., Power:, Mechanical data:, , • Dimensions (W x H ):, In the package:, • 2 SMD preassembled, programmed and tested boards already mounted and soldered, Links:,
8 ESCs on two boards! Extremely fast brushless controllers version ...ngHobbies
DOUBLE QUADRO 2XL - COMBI
| • voltage | 10 to 30V -> 3 -7S Lipo |
| • current | up to 60A (per BL-Unit) and 120A (all together) with appropriate cooling |
| • Silent Start | test tone at startup can be disabled |
| • hole | 3mm |
| • weight | ca. 109g |
IMPORTANT:, Use FlightCtrl Firmware V2.02 (or greater), otherwise read the instructions in the wiki !, : The BL-Ctrl 3.0 controller is specifically designed and optimized for our motors. For maximum stability of the MikroKopter set-points are set almost instantaneously on the motor. If other motors (especially larger power classes) are used with this controller, this fast change of set-points can easily lead to very high peak currents, which bring the BL-Ctrl control to the limit or an overload. This is no fault of BL-Ctrl3.0 controller, but a systemic property., Power:, Mechanical data:, , • Dimensions (W x H ):, In the package:, • 2 SMD preassembled, programmed and tested boards already mounted and soldered, Links:,
8 ESCs on two boards! Extremely fast brushless controllers version ...ngHobbies
DOUBLE QUADRO V3 - COOL
| • voltage | 10 to 30V -> 3 -7S Lipo |
| • current | up to 60A (per BL-Unit) and 120A (all together) with appropriate cooling |
| • Silent Start | test tone at startup can be disabled |
| • hole | 3mm |
| • weight | ca. 109g |
IMPORTANT:, Use FlightCtrl Firmware V2.02 (or greater), otherwise read the instructions in the wiki !, : The BL-Ctrl 3.0 controller is specifically designed and optimized for our motors. For maximum stability of the MikroKopter set-points are set almost instantaneously on the motor. If other motors (especially larger power classes) are used with this controller, this fast change of set-points can easily lead to very high peak currents, which bring the BL-Ctrl control to the limit or an overload. This is no fault of BL-Ctrl3.0 controller, but a systemic property., Power:, Mechanical data:, , • Dimensions (W x H ):, In the package:, • 2 SMD preassembled, programmed and tested boards already mounted and soldered, Links:,
8 ESCs on two boards with extra cooling through assembled ...